The "Flow is stopped because it has run for 600 seconds, which is the flow timeout" error message appears when the execution time taken by the automation flow exceeds the maximum run time allowed for a flow (by default the value is set to 600 seconds).
This is a flow-level setting. Here is the way to update it to greater value:
-
Open the relevant flow
-
After the flow is in the opened state, click on the three vertical dots in the top-right corner of the Canvas toolbar, then go to the Settings tab as shown in the screenshot below:
3. After clicking the Settings tab, the Flow Settings will be opened. Under the Run category, the user can change the Max run time, seconds option based on the size and complexity of the flow, then save the settings.

Note: Please note that the above settings will be applicable only at the flow level i.e. for the flow for which these settings have been changed and saved. If the user wants to increase the flow execution timeout for all of their automation flows, the user will need to increase the ‘Max run time, seconds’ setting in the Default Flow Settings category inside the Leapwork Studio. To know more, Click here
For any clarification, please contact our Priority Support.
Comments
0 comments
Please sign in to leave a comment.